Voyager Extension Table

Objective:     Add an extension table to Voyager 17 without voiding any warrantee provisions. 

                     That meant no new holes etc.

Back to the junk in the shop:

Found a couple of angle brackets, metal strips a few washers, and screws.

Saw a special in a flyer for a cutting board for $5.95 (saved me a lot of sanding & finishing.

Result in pictures.  Plus one happy quilter.

Attached the two metal strips with spacer washers behind.

Used the holes already in the Voyager base put there by Hinterberg

As you can see I did not measure correctly first time.

A trait I learned from a quilter  ...   LOL

Installed...   Still waiting for inspection by quilt police.

May have to file a little off the top edge of metal strips to lower the table.  Must satisfy inspector.

   by  ...   DH Bob